For an Agent With Its Own Wallet
Your agent proposes, you approve. Paste each draft before you confirm it in your wallet, and keep your usual recipients in the address book.
Uses: review, address book
See what your agent wants to send before you approve it. Paste the transfer draft and your original instruction: Sentra shows the full recipient, the amount in ETH and wei, and every field that does not match.
Early concept, built as a working prototype for Robinhood Chain Testnet. It only reads drafts: it never signs or sends, and it needs no $SENTRA.
Reads the drafts agents actually produce
reading…
Robinhood Chain Testnet block, read live
40 / 40
address characters shown, in groups of four, never cut
0
signatures: Sentra reads, your wallet signs
The agent's draft is read exactly as a wallet would read it, then compared with what you asked for: recipient, amount, network. Anything ambiguous (a repeated field, two networks, a value with a decimal point) is refused, never guessed.
Instruction: “Send 0.25 ETH to the address below”
0x5aAeb6053F3E94C9b9A09f33669435E7Ef1BeAedDraft from the agent
0x5AaeB6C1d7f04e2B98a3e6f7012c4D5B8E1bEaeDChecksummed and split into ten groups of four. Characters that differ from your instruction are marked, so a swapped middle cannot hide.
0.25 ETH is 250,000,000,000,000,000 wei. A draft that moves the decimal point shows the exact factor it is off by.
A non-empty data field means a contract call. Token transfers, approvals and EIP-7702 delegations are named and stopped.
Contract or plain account, transactions sent, balance and first-seen date, read from the network the draft names.
One paste covers the whole transaction, and each field says where its value came from.
40
hex characters
Compared one by one with the instruction and your address book.
18
decimals of wei
Amounts parsed exactly, no floating point, no rounding.
2
networks read live
Robinhood Chain Testnet (46630) and Robinhood Chain (4663).
0
drafts stored
The review runs in your browser. Only addresses are sent for live facts.
Full, checksummed, look-alike tested.
ETH and wei, matched to the instruction.
Testnet, mainnet or refused.
Against the sender's next nonce, live.
Empty for a transfer; calls decoded.
Signer recovered from signed hex.
Worst-case fee, cap against base fee.
First seen, transactions, contract or not.
What you see in Sentra, in a typical wallet pop-up, and in the agent's own message.
Recipient
Sentra: All 40 characters, grouped, differences marked
Wallet pop-up: Often shortened to the first and last few
Agent's message: Whatever the agent chose to write
Amount
Sentra: ETH and exact wei, compared to your words
Wallet pop-up: ETH, rounded on some screens
Agent's message: In words, may differ from the transaction
Hidden token call
Sentra: Decoded and stopped
Wallet pop-up: Depends on the wallet
Agent's message: Not visible
Look-alike of a known address
Sentra: Flagged against your address book
Wallet pop-up: Usually not checked
Agent's message: Not checked
Network
Sentra: Chain id named; two networks in the text is refused
Wallet pop-up: Shown as the current network
Agent's message: Often not stated
Signs or sends
Sentra: Never
Wallet pop-up: Yes, that is its job
Agent's message: May, if it holds a key
Wallets differ; the middle column describes common behaviour, not any one product. Use Sentra next to your wallet, not instead of it.
Raw hex, JSON or the agent's own words. Nothing is uploaded or stored.
Open the reviewA look-alike address with the same first and last characters lands in your history through a zero-value transfer, and the agent copies it. Sentra compares all 40 characters with your instruction and your saved addresses.
0.25 becomes 2.5 or 0.025 between your sentence and the transaction. Sentra converts both to wei and names the factor.
An approval or a token transfer hides in the data field while the recipient looks familiar. Sentra decodes the common ones and stops on any non-empty data.
A testnet instruction signed on mainnet moves real ETH. Sentra reads the chain id and refuses drafts that name both networks.
From one person and one agent to a team approving a shared wallet.
Four parts, each labelled with what really runs today.
Write what you asked the agent for, in your own words. Sentra reads full addresses, amounts with a unit (ETH, gwei, wei) and network words from it, and checks the draft against each. Names like alice.eth and dollar amounts are reported as not checked, never resolved or converted.
Save the addresses you pay often, with a label. They stay in this browser. Every review compares the recipient with each of them: an exact match is named, and an address that shares the ends but not the middle is stopped.
Saved: Rent account
0x5aAeb6053F3E94C9b9A09f33669435E7Ef1BeAedRecipient in the draft
0x5AaeB6C1d7f04e2B98a3e6f7012c4D5B8E1bEaeDFor the network the draft names, Sentra reads whether the recipient has code (a contract, or an account delegated through EIP-7702), how many transactions it has sent, its balance, and its first transaction from the network's public explorer. If a read fails, the point is marked not checked.
Once you approve, record the exact transfer on Robinhood Chain Testnet: recipient, amount, chain, expiry and a hash of your instruction (the text stays with you). Your agent can call check() before sending, or pay through the forwarder, which refuses anything that is not an approved, unexpired, unused intent. Written and tested, not deployed yet.
check(approver, from, to, value, expiry, salt, instructionHash)
→ Approved
forward{value: 0.25 ETH}(…)
→ paid once, then Used
Sample dataThe review is free and needs no wallet. Recording an approval is optional and costs testnet gas.
Paste, read, decide. Runs in your browser, works without connecting a wallet, keeps nothing. The address book lives in this browser only.
Put the approved transfer on chain so the agent can prove it was approved before it sends. Revoke it any time before it is used.
STEP 1
Raw hex, JSON or the agent's message, plus the instruction you gave it.
STEP 2
Stops, warnings, matches and anything not checked, each with the reason.
STEP 3
Sign only if the review and your wallet show the same transfer. Optionally record it.
It reads a transfer draft your AI agent produced and shows it in full next to the instruction you gave: the whole recipient address, the amount in ETH and wei, the network, nonce, gas and data. It flags anything that does not match, look-alike addresses, and contract calls hidden in the data field.
No. The review only reads. Your wallet signs. The optional intent ledger is a separate step where you sign a transaction yourself to record an approval on Robinhood Chain Testnet.
The draft and the instruction are parsed in your browser and never stored. To read live facts, the recipient and sender addresses (only those) are sent to Sentra's server, which asks the network's RPC and public explorer.
Raw transactions in hex (EIP-1559, EIP-2930, legacy, EIP-7702; signed or unsigned), JSON transaction objects or eth_sendTransaction requests using the exact field names wallets use, and plain text such as "Send 0.25 ETH to 0x… on testnet". Anything ambiguous, such as a field given twice or both networks named, is refused rather than guessed.
Not necessarily. Sentra checks the points it lists and nothing else. It cannot know whether the address in your instruction is the right person, and a point it could not read is marked not checked. Compare the review with what your wallet shows before you sign.
The product is an early concept, so it is aimed at the testnet (chain 46630) first, where mistakes cost nothing. Mainnet (4663) drafts are read too and marked as real funds.
SentraIntentLedger and SentraGuardedForwarder are new contracts, tested but not yet deployed. The forwarder passes ETH to the recipient inside one transaction and keeps nothing; even so it should have an independent security review before it handles real amounts. Start with test ETH.
No. Every feature works without it. $SENTRA has not launched; its address will be published on this site and on X @sentra. Any perks are a concept, not built.
Paste a raw transaction, a JSON draft or the agent's text, plus your original instruction. Sentra shows the full recipient, ETH and wei, network, nonce, gas, data, and checks them against the instruction.
Limit: Runs in your browser. Reads only: it never signs, sends or stores the draft. Names (alice.eth) and dollar amounts are not resolved.
Compares the recipient with the addresses in your instruction and in an address book kept in this browser; same first and last characters with a different middle is flagged.
Limit: Only addresses you saved or typed are compared. A brand-new wrong address that looks like nothing you know is caught only by the instruction match.
Contract or plain account (and EIP-7702 delegation), transactions sent, balance, first-seen date and transaction count, read live from Robinhood Chain Testnet or mainnet.
Limit: First-seen and counts come from the network's public explorer; when it does not answer they show as not checked, never as zero.
SentraIntentLedger records an approved transfer (recipient, amount, chain, expiry); an agent can check it before sending, and SentraGuardedForwarder pays only a matching, unexpired, unused intent.
Limit: Written and tested (forge, including Robinhood Chain fork tests), not deployed yet. The forwarder moves ETH inside one transaction; it needs an independent security review before real amounts.
The same checks inside the signing flow, without copy and paste.
Limit: Not built.
Reviews for ERC-20 and NFT transfers, not only ETH.
Limit: Not built. Token calls in the data field are decoded and flagged today, not reviewed as transfers.
Possible holder perks for future hosted features.
Limit: Not built. Every feature above works without the token.